JNTUH B.Tech - R22, R18 - Structural Analysis II (SA- II ) - Notes / Important Question and Objective Bits
Download Here
JNTUH B.Tech - R22, R18 - Structural Analysis II (SA- II ) Syllabus
UNIT - I :
Materials – Types of structural steel – Mechanical properties of steel – Concepts of plasticity – yield strength - Loads and Stresses – Local buckling behavior of steel. Concepts of limit State Design – Different Limit States – Load combinations for different Limit states - Design Strengths - deflection limits – serviceability – stability check. Design of Connections– Different types of connections – Bolted connections – Design strength – efficiency of joint– prying action - Welded connections – Types of welded joints – Design requirements - Design of Beam-column connections - Eccentric connections - Type I and Type II connection – Framed connection– stiffened / seated connection.
UNIT - II :
Design of tension members –Simple and built up members - Design strength – Design procedure for splicing - lug angle.
Design of compression members – Buckling class – slenderness ratio – Design of simple compression members - laced – battened columns – splice – column base – slab base.
UNIT - III :
Plastic Analysis; Plastic moment – Plastic section modulus - Plastic analysis of continuous beams Design of Flexural Members – Laterally supported and unsupported Beams – Design of laterally supported beams - Bending and shear strength/buckling – Built-up sections - Beam splice
UNIT - IV :
Design of welded plate girders – elements – economical depth – design of main section – connections between web and flange – design of stiffeners - bearing stiffener– intermediate stiffeners – Design of web splice and flange splice.
UNIT - V :
Design of Industrial Structures; Types of roof trusses - loads on trusses – wind loads - Purlin design – truss design – Design of welded Gantry girder Note: Design of structural members include detailed sketches.
Download Here
JNTUH B.Tech - R22, R18 - Structural Analysis II (SA- II ) Syllabus
UNIT - I :
Materials – Types of structural steel – Mechanical properties of steel – Concepts of plasticity – yield strength - Loads and Stresses – Local buckling behavior of steel. Concepts of limit State Design – Different Limit States – Load combinations for different Limit states - Design Strengths - deflection limits – serviceability – stability check. Design of Connections– Different types of connections – Bolted connections – Design strength – efficiency of joint– prying action - Welded connections – Types of welded joints – Design requirements - Design of Beam-column connections - Eccentric connections - Type I and Type II connection – Framed connection– stiffened / seated connection.
UNIT - II :
Design of tension members –Simple and built up members - Design strength – Design procedure for splicing - lug angle.
Design of compression members – Buckling class – slenderness ratio – Design of simple compression members - laced – battened columns – splice – column base – slab base.
UNIT - III :
Plastic Analysis; Plastic moment – Plastic section modulus - Plastic analysis of continuous beams Design of Flexural Members – Laterally supported and unsupported Beams – Design of laterally supported beams - Bending and shear strength/buckling – Built-up sections - Beam splice
UNIT - IV :
Design of welded plate girders – elements – economical depth – design of main section – connections between web and flange – design of stiffeners - bearing stiffener– intermediate stiffeners – Design of web splice and flange splice.
UNIT - V :
Design of Industrial Structures; Types of roof trusses - loads on trusses – wind loads - Purlin design – truss design – Design of welded Gantry girder Note: Design of structural members include detailed sketches.
Last edited: